Install In 15 Minutes Or Less!

Available for the Harley-Davidson touring models only. Available in three heights for standard suspensions, lowered rear suspension and lowered front and rear suspensions..

Model CS-1 - Center Stand for STOCK Suspensions - Standard Height Model This model EZ-UP Center stand fits the standard height suspensions on 1989 and later Harley-Davidson touring motorcycles. This is the center stand needed for all FL touring bikes which have the bowtie brace welded between the frame rails directly below the transmission.

NOTE: The length of standard height rear shocks are 12-3/4 inches. Measure the mounting bolts from center-to-center to check this dimension.

Model CS-2 - Center Stand for LOWERED Suspensions REAR ONLY - This model EZ-UP Center stand is for H-D touring motorcycles which are lowered in the REAR only. This model is ¾ inch lower than the stock center stand and fits the factory-lowered models like the FLHX Street Glides and FLHRS Road King Customs, and any bike that has been lowered with the H-D Profile REAR suspension lowering kits.

NOTE: The length of lowered rear shocks are 11-3/4 inches. Measure the mounting bolts from center-to-center to check this dimension.

Model CS-3 - Center Stand for LOWERED Suspensions FRONT & REAR - This model EZ-UP Center stand is for Harley-Davidson touring motorcycles which have been lowered in the FRONT and REAR. This model is 1 inch lower than the stock center stand and fits the factory lowered FLHX Street Glides the FLHRS Road King Customs, and any touring model that has been lowered with the H-D Profile FRONT and REAR suspension lowering kits.

• Limited lifetime warranty. 
• Mounts to the frame with two bolts in less than five minutes with a 3/4 inch wrench.
• EZ-OFF by simply placing the bike in gear and driving off.
• No frame or bike modification required.
• Maintenance free stand with I-Glide self lubricating bushings at the pivot locations
• Made in the USA